1. The support rod is short of oil or deformed. If the abnormal sound comes from the support rod, first check its lubrication status. Lack of oil will cause direct friction of metal parts to produce abnormal noise. At this time, butter or WD-40 lubricant can be used to smear the active parts of the support rod. During operation, the joints must be evenly covered and the tail box must be opened and closed repeatedly to penetrate the lubrication. If there is still abnormal sound after lubrication, you need to check whether the support rod is deformed - long-term load bearing or external impact may cause the rod body to bend. At this time, a new rod needs to be replaced, which costs about 100 yuan online. During installation, ensure that the rod body is aligned with the trunk and frame fixed points.
2. Loose hinge screws The hinge is a key component connecting the trunk and the frame. Loose screws will cause gaps between the metal parts, causing abnormal sounds when they are opened and closed. Use a wrench to check the fixing screws at the hinge one by one. If they are found to be loose, tighten them to the appropriate strength to avoid over-tightening that may cause thread damage. If the screw slide or the hinge body is cracked, the entire hinge assembly needs to be replaced.
3. 80% of abnormal noises are caused by collision of objects or improper fixation. The trunk must be emptied first and confirmed by a test drive. If the abnormal noise disappears, the items need to be rearranged: it is recommended that small items (such as tools, chargers) be placed in a storage box with Velcro and fixed to the inner wall of the trunk with Velcro; heavy objects (such as batteries) should be placed close to the rear seats and reinforced with straps; sharp objects should be wrapped in soft materials to avoid direct contact with metal parts.
4. If the lock buckle is worn or loose and the lock buckle is not tightly engaged, it will cause the trunk to shake and produce abnormal noise when it is closed. If it is slightly loose, you can use pliers to slightly adjust the angle of the lock to make it fit more closely with the trunk buckle; if the lock is severely worn (such as broken teeth, aging plastic), you need to replace the lock with a new one. During installation, make sure that the lock and buckle are aligned to avoid secondary damage caused by forced closing.
5. Aging of the buffer pad or sealing strip. The aging of the buffer pad will reduce the shock-absorbing effect between the trunk and the frame. Electrical tape or foam tape can be temporarily attached to the contact surface to increase the buffer layer. If the sealing strip appears cracked or hardened, a D-type sealing strip can be temporarily added to enhance the sealing. If it is seriously aged, it is recommended to replace the original sealing strip. Clean the contact surface before installation and ensure that the sealing strip is completely fit.
6. The height of the shock-absorbing rubber pad is abnormal. The shock-absorbing rubber pad is used to adjust the closing strength of the tail box. If the height of the rubber pads on both sides is inconsistent, it will cause the tail box to tilt and collide. Check whether the rubber pad is detached or deformed. You can adjust the height by rotating the rubber pad so that the force on both sides is even when the trunk is closed to avoid abnormal noise caused by excessive extrusion on one side.
